Are you looking for:

Dayton & Dual Wheel Adapter for Big Truck Tire Step - (Adapter Bar Only)

The 5950 Dual Wheel Adapter must be used when using the Big Truck Tire Step on Dayton and dual wheels.

This adapter provides extra stability by resting against the tire when there is no rim to rest against. The Dual Wheel Adapter is included with the 5800 Super Single 2-Step and the 5300 Super Single 3-Step.

The Dual Wheel Adapter can be easily attached to any Big Truck Tire Step by sliding the adapter’s two attachment posts over the step’s rear stabilizing posts. Secure the adapter with the included screws and nuts.

Super Single Model numbers 5800 and 5300 come pre-drilled for the adapter. If using the dual wheel adapter with model numbers 5500 or 5100 you must: 1) Remove vinyl caps. 2) Slide on adapter and mark hole placement. 3) Drill holes in the stabilizing posts. 4) Attach Dual Wheel Adapter.

*Note: This is the adapter bar only. Steps are sold separately.

Wheel Guard, 10 Hole, 285.75mm B.C., Hub-Piloted, 22mm Studs, Unimount
Prevents rust, scale, corrosion, and galvanic electrolysis on disc wheels. Nylon separator plate, placed between the hub or drum and the wheel, and/or between two wheels on dual applications. The wheel-guard is highly recommended in severe applications where corrosion and/or wear has been identified as a problem. Both aluminum and steel wheels can benefit from wheel-guard.
Precision Instruments M2R200HX 3/8" Drive Torque Wrench 30-200 lb.in.

Engineered, precision bearing surfaces extend the calibrated life of the M line to as many as 60,000 cycles or more and ensure the most reliable performance possible. In addition to flawless operation at release, calibration is completely external, unlike traditional mechanism that require disassembly and the replacement of blocks and shims.

  • Drive Size: 3/8"
  • Drive Type: Rigid Ratchet
  • Primary Units: lb.in
  • Capacity: 30-200
  • Increments: 1
  • Effective Length at 20% of Full Scale: 8.18" Effective Length at Full Scale: 7.28"
  • Maximum Overall Length: 9.87"
  • Minimum Overall Length: 8.97"
  • Weight: .85 lbs. (w/plastic case): 1.50 lbs.
  • Finish: Nickel / Chrome
  • Ratchet kit: R21AR-RK
  • Meets or Exceeds the following Specifications: GGG-W-686C, ANSI B107.14M
Kiene: Engine Mounting Adapter for Detroit Diesel 71 Series, 92 Series

Engine adapter for Detroit Diesel 71 Series 6V & 8V, 92 Series 6V & 8V Engines.


A large assortment of engine mounting plates are available for mounting various makes and models of engines as well as transmissions to the KIENE engine rebuild stand. They provide simple attachment to the engine using mounting pads and holes provided by the engine manufacturer, thus emilinating, where possible, removal of accessory equipment from the engine.

Kiene: Adapter, Ermeto End 1/2" - 20, 20 LH(M) with 60 Degree Seat x 1/2 - 20 LH(F)
Adapter, Ermeto End 1/2" - 20, 20 LH(M) with 60 Degree Seat x 1/2 - 20 LH(F) for DT-1300 Diesel Injector Nozzle Tester
Loading...